Holybro PM06 V2-14S Power Module 2S-14S5.2V For Aircraft Flight Controller Accessories Item NO.: F48712

Holybro PM06 V2-14S Power Module  2S-14S5.2V For Aircraft Flight Controller Accessories

PM06 V2-14S Power Module

Description:
This PM06 Power Module supplies clean 5.2V to flight controller from the battery and provides current consumption
and battery voltage measurements via analog signal through a 6 Pin JST-GH cable, along with integrated power
distribution for 4 ESCs. It comes with pre-soldered wires, capacitor, and XT60 connector.

Technical Specification：
Input voltage: 2S-14S
PCB Cont. Current Rating: 70A
PCB Burst Current Rating: 120A (<60 Sec)
Output: DC 5.2V & 3A Max (Note: To ensure proper heat dissipation, UBEC output current needs to be limited to
<2A when using 14S battery.)
Voltage Divider: 18.182
Amperes per Volt: 36.364

Please Note:
- The XT60 Plug and 12AWG wire that are pre-soldered on the board is rating for 30A continuous current and 60A burst
current (< 60 Seconds). If a higher current is being used, the plug type and wire size should be changed
accordingly. You can refer to this chart for reference.
- This PM02 Power Module uses analog data output and is not compatible to the Pixhawk 5X & 6X (Requires a digital
PM like PM02D).  

Mechanical Specification:
Dimensions: 35x35x5mm
Mounting hole: 30.5mm*30.5mm
Weight: 24g
Pin Map:

Package Include：
1x Power Module
1x 80mm XT60 connector wire (pre-soldered)
1x Electrolytic capacitor: 220uF 63V (pre-soldered)
1x JST GH 6pin cable