Product Name | JMT Betaflight JHEMCU F7BT Dual Flight Control OSD BEC 5V 8V Control Dual Gyroscope for DJI VTX for FPV Racing Drone Quadcopter |
Item NO. | F37053 |
Weight | 0.05 kg = 0.1102 lb = 1.7637 oz |
Category | DIY RC Drone Accessories > Flight Control |
Brand | JMT |
Creation Time | 2020-04-10 |
Note: After receiving the flight control, please do not be busy soldering the wires. Connect to the computer with USB first, make sure that the LED of the flight control is blinking, and it can connect with the computer BF software normally, then go to the welding installation. If the flight control does not respond after welding without testing, we will always consider it to be caused by human damage. In this case, we will not accept returns or exchanges.
JHEMCU F7BT Dual adopts STM32F722RET6 high-performance processor, ICM2689 + MPU6000 dual gyroscope, and switches the sensor through CLI commands. Integrated OSD, built-in 5V / 2A (internal power supply, receiver, LED, BUZZER, etc.), 8V / 3A BEC (powered by camera and image transmission mode, which can be turned on and off through USER2), two independent BEC work separately , Do not interfere with each other, optimized circuit design, high-performance hardware, further guarantee the powerful performance of flight control. Supports two camera inputs (VIN1, VI2 are video input interfaces, controlled by USER1 switching, and VIN1 is the default input signal). Perfect interface definition, leaving out the available interfaces. In addition, 8P and 6P 1.0MM sockets are also designed to facilitate direct input of plug wires. Built-in 16MB on-board memory, with 16kHz recording rate, record flight data, so that the assistant can support 32K update frequency. Reserve DJI Sky VTX special socket interface, with special plug cable. Support Bluetooth online parameter adjustment.
technical parameter:
Model: JHEMCU F7BT Dual
Main control chip: STM32F722RET6 216MHz
Gyroscope: Dual ICM20689 + MPU6000 dual gyroscope access (SPI)
Barometer: BMP280
OSD chip: AT7456E
Black box: 16MB
LED programming: support
BB ring: Support
Input voltage: 2-6S
I2C interface: support
BEC-1: 5V / 2A (internal power supply, receiver, LED, BUZZER, etc.)
BEC-2: 8V / 3A (powered by camera and image transmission mode, it can be turned on and off through USER2)
Dual camera input: support (VIN1, VIN2 are video input interfaces, switch control by USER1, default VIN1 is input signal)
Serial control ports: six (UART1, UART2, UART3, UART4, UART5, UART6)
Bluetooth: support (port UART4, baud rate 115200, name JHEMCU)
DJIVTX: support sky-side reserved special socket, equipped with special plug line
Flight Control Firmware: Betaflight
Goal: JHEF7DUAL.HEX
Conversion between hole position and shock absorbing hole position: 30.5 * 30.5mm, φ4mm
Flight control size: 36 * 36mm
Weight: 7.3g
CLI:
status // Sensor status query
set gyro_to_use = FIRST // ICM20689 switch
set gyro_to_use = SECOND // mpu6000 switch
save // SAVE after entering
packing list:
JHEMCU F7BT Dual Flight Controller * 1
M3 shock ball * 4
DJIVTX 8P-6P plug line * 1
SKYPE: +8615012643826
Email:yxy@xt-xinte.com
No related record found