JMT External LED Controller with RGB LED Strip for APM Pixhawk Ardupilot PX4 RGB Navigation Light Quadcopter Hexacopter Drone Plane Item NO.: F35340

JMT External LED Controller with RGB LED Strip for APM Pixhawk Ardupilot PX4 RGB Navigation Light Quadcopter Hexacopter Drone Plane

Package included:
1 x LED controller
6 x RGB LED strip
1 x USB to UART module
Stickers
Cables
User manual

Features:
The LED Controller includes a controller board, 6 sets highlight LED strips and one USB to UART module. It is compatible with any flight controller with ardupilot or PX4 firmware like Pixhawk serial, APM serial, Pixracer, NAVIO2, PXFmini etc. It is compatible with Mavlink 1 and Mavlink 2
The front 2 LEDs (F1 and F2) show the orientation of the aircraft and get solid when the aircraft arm, breathe when disarm. The color is changeable via the configurator
The rear 2 LEDs (R1 and R2) show the status of the aircraft(GPS, RC failsafe, low battery, critical low battery, flight mode changing). Refer to the table below for more information about the aircraft status
Other 2 LEDs (F3 and F4) show solid color. The color is changeable via the configurator
All LEDs can Turn on/off via one of the Ch6 to Ch16
Aircraft status LED (R1 and R2)states

Color
Blinking/solid
Description of the state
green
Blinking slowly
GPS locked
blue
Blinking slowly
GPS not lock
yellow
Blinking quickly
Low battery
pink
Double blinking
RC failsafe
red
Blinking quickly
Critical low battery
pink and yellow
Blinking alternatively
RC failsafe and low battery
pink and red
Blinking alternatively
RC failsafe and Critical low battery
white
Blinking once
Flight mode changing

The small blue LED on the controller will indicate whether the Mavlink message received. Blinking when not receiving Mavlink message, solid when getting Mavlink message.
The LED strip will alternately flash when not receiving the Mavlink message. It will work normally when receiving the Mavlink message
 
Rating current:
200mA @8 LED beads
300mA @12 LED beads
600mA @26 LED beads. 

Cable length for LED: 350mm
Max support 4 LEDs for one strip

Notice:
When more than 12 LED beads are used, the telem port of Pixhawk can not supply enough power, so you need power the Mavlink controller from an external 5V source
 
Download the LED Controller configurator APP
The LED Controller needs to be configured, so it can work properly. Go to the address below to download the APP. 
https://drive.google.com/open?id=16ISVCYHlCFOZCIm8QLmbSH6-WIMl3JPE